Spraying Technique; Breaks In Work; Finishing Work And Cleaning The Unit - WAGNER FineCoat 7000 S Mode D'emploi

Spraying technique

Hold the paint spray gun upright and maintain a constant
distance of about 3 - 20 cm to the object being sprayed.
Move the paint spray gun evenly either from side to side or
up and down. If the gun is moved evenly, it will produce an
even surface finish. No runs will occur if the speed is correct.
Always start spraying away from the object and avoid stop-
ping spraying whilst still on the object.
Note: If the round jet setting is used, the distance may be in-
creased according to the size of the object being sprayed.
•
In case of excessive paint mist formation, adjust the air
and material flow respectively and alter the distance from
the object.
Right

3 – 20 cm
Wrong
Excessive paint mist formation, uneven surface finish

16
All manuals and user guides at all-guides.com
GB

Breaks in work

•
Turn the material regulating knob to the right as far as it will
go (fig 11).
This will secure the paint spray gun against unintentional
operation.

•
Switch the unit off.

Finishing work and cleaning the unit

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Switch the unit off.
Hold the paint spray gun in the original container.
Press the trigger to release the pressure in the spray gun
container.
Undo the paint container closing lever and remove the
container.
Empty the remaining coating material into the original
container.
Fill the spray gun container with solvent or water and fit
onto the spray gun.
Only use solvents with a flash point above 21 ° C.
Shake the paint spray gun well.
Switch the unit on and spray the solvent or water into an
open container.
Caution!
Never spray into a container with only a small
opening (bunghole)! See safety regulations.
Repeat this procedure until the solvent or water coming
out of the tip is clear.
Then empty the paint container completely.
Caution! Never leave solvents in the spray gun
container; this may cause pressure to build up in the
container.
Always keep the paint container seal clean of left over
coating material and check regularly for signs of damage.
Switch the unit off.
Clean the outer surfaces of the paint container and
paint spray gun with a cloth soaked in solvent or water.
Note: Do not leave the FineCoat spray gun immersed in
solvent for extended periods! (The seals and air pipe on non-
return valve may swell, preventing them from functioning
properly.)
Unscrew adjusting ring, remove air cap and
spring plate. Unscrew nozzle. Clean air cap, tip
and needle with brush and solvent or water.
Note: Never use sharp metal objects to clean the nozzles
or air channels of the FineCoat spray gun.
FineCoat 7000 S