Start & Stop Procedure; Preparing The Porto Screed For Use - Altrad BELLE PRO SCREED Manuel De L'opérateur

GB
Honda GX240 Petrol Engine
1. Open the fuel tap by moving the fuel ON / OFF lever fully to the right.
2. If starting the engine from cold, set the choke ON by moving the choke lever fully
to the left. If restarting a warm engine, the choke is usually not required, however, if
the engine has cooled to a degree, partial choke may be required.
3. Turn the engine ON / OFF switch clockwise to the 'I' position.
4. Set the throttle to the idle position by moving the throttle lever fully to the right. Do
not start the engine on full throttle.
5. Taking a rm hold of the control handle with one hand, grasp the recoil starter
handle with the other. Pull the recoil starter until engine resistance is felt, then let
starter return.
6. Taking care not to pull the starter's rope fully out, pull the starter handle briskly.
7. Repeat until the engine res.
8. Once the engine res gradually set the choke lever to the OFF position by moving it to the right.
9. If the engine fails to re after several attempts, follow the troubleshooting guide.
10. To stop the engine, set the throttle to idle and turn the engine ON/OFF switch anti clockwise to the 'O' position.
11. Turn the fuel off.
Electric
1. Connect the machine to the relevant power source.
2. Press the green button to start the machine.
3. Press the red button to stop the machine.
Pneumatic
1. Connect the machine to an appropriate pneumatic source.
2. Ensure that the in line oiler is full and that it is set for the correct dispersal rate.
3. To start the machine vibrating, fully open the control valve.
4. To stop the machine vibrating, fully close the control valve.
GB
Change worn or frayed cables - cables under tension may snap and cause injury. Use proper methods to
CAUTION
hook cables. Always connect cables properly.
• Inspect your machine for damage or tampering that can sometimes occur in transporting.
• Replace worn,frayed or damaged cables. A damaged cable can break under tension, snap back and injure anyone in the area.
• Cables must be connected properly (See 'Operation' section). Do not hook a cable to a stake that is just driven into the ground.
They can tilt when under tension and allow the cable to snap back and cause injury.
• Only trained personnel should operate your Pro-Screed.
• Your Pro-Screed will provide years of service if properly used and maintained.
• Keep the machine clean using a release agent to prevent concrete accumulation.
• Clean the machine as soon as use has ended.
• Clean the front blade of any concrete deposits while waiting for concrete delivery.
• What is the required surface tolerance?
• Choose screed type and size based on the above information.
• Are any accessories required?
Proper adjustment of all components and accessories.
• Are all of the bolts tight?
• Do the winches work properly (under load)?
• Adjusting the screed for surface pro le.
• Are jam nuts tight?
Do a dry run. This will ensure that everything works properly.
Start and Stop Procedure
Preparing the Pro Screed For Use
10
Throttle Lever
Choke Lever
Fuel ON/OFF
Lever.