Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLING/REMOVING THE PERSONAL
BACK10
NOTE: For this procedure refer to FIGURE 1.5.
The position of the Personal Back10 in the three (3) different mounting bracket
slots is directly related to the chair's stability. When the Personal Back10 is added
to a TILT and/or RECLINING chair, it may cause a decrease in the chair's stability.
It may be necessary to reposition the FRONT CASTERS, REAR WHEELS, BACK
ANGLE, TILT-IN-SPACE, RECLINE POSITION and/or SEAT DEPTH before use.
Use extreme caution when using a new seating position.
NOTE: There are two (2) different back angle adjustments. Refer to Adjusting The Personal
Back10 Angle on page 15 before installing the Personal Back10.
1. Install the Personal Back10 onto the mounting plate so that the studs locate into the
appropriate slots as shown in DETAIL "A" of FIGURE 1.5.
2. With mounting pin in the UNLOCKED position, align tear drop with one (1) of the
three (3) sets of side bracket back mounting holes as shown in DETAIL "B" of FIGURE
1.5.
3. Install mounting pins into mounting holes.
4. To lock, rotate the mounting pins downward to the LOCKED position as shown in
DETAIL "B" of FIGURE 1.5.
Make sure hook and loop straps are securely holding the mounting pins. The
Personal Back10 may come loose if the mounting pins are not locked down.
5. Secure mounting pins from rotating with hook and loop straps on back of cover.
6. To remove the Personal Back10, reverse STEPS 1-5.
NOTE: Mark the upper and lower mounting positions of the Personal Back10 mounting bracket
for reference by family or caregivers.
Part No 1114817
SECTION 1—ENGLISH INSTRUCTIONS
WARNING
WARNING
13
Personal Back™10 Personal Back™10 Plus
Publicité
Table des Matières
