Use Of The Personal Back10; Adjusting The Personal Back10 Depth - Invacare Personal Back 10 Manuel De L'utilisateur Et D'entretien

SECTION 1—ENGLISH INSTRUCTIONS
DETAIL "A"
Stud
FIGURE 1.5 - INSTALLING/REMOVING THE PERSONAL BACK10

USE OF THE PERSONAL BACK10

The Personal Back10 includes a movable foam lumbar pad attached to the back shell with
hook and loop fasteners to provide additional positioning capability. To access the lumbar
pad, unzip the cover and push the foam forward, away from the back of the shell. The
lumbar pad will then be accessible for making adjustments.

ADJUSTING THE PERSONAL BACK10 DEPTH

NOTE: For this procedure refer to FIGURE 1.6.
NOTE: The Personal Back10 depth can be adjusted in relation to the back canes by 2-1/4-inches in
increments of 3/4-inches.
NOTE: Some back angle adjustments affect which seat depth adjustments are available. Refer to
Adjusting The Personal Back10 Angle on page 15.
NOTE: Perform this procedure on one side plate at a time.
NOTE: If necessary, remove the Personal Back10 from the wheelchair. Refer to Installing/
Removing The Personal Back10 on page 13.
1. If necessary, remove the side plate from the back canes. Perform the following as
shown in DETAIL "A" of FIGURE 1.6:
A. Remove the two cap nuts that close the cane clamps around the back cane.
B. Open cane clamps and remove the side plate and cane clamps from the back cane.
C. Remove the two (2) mounting bolts and cane clamps from the side plate.
2. Select the side plate mounting hole that matches the desired back depth for both cane
clamps. Note side plate mounting hole locations on the side plate.
Personal Back™10 Personal Back™10 Plus
Mounting
Bracket
(Slots)
14
DETAIL "B"
Mounting Pin
Tear Drop
Side Plate Back Mounting Holes
Side Plate Back Mounting Holes
Mounting Pin
Hook and Loop Straps
Tear Drop
LOCKED
UNLOCKED
Part No 1114817