Invacare Personal Back 10 Manuel De L'utilisateur Et D'entretien page 12

SECTION 1—ENGLISH INSTRUCTIONS
2. From the inside of the side plate, insert a mounting bolt through the side plate and
cane clamp as shown in FIGURE 1.4.
3. Align cane clamp mounting hole with the desired lower side plate mounting hole.
4. From the inside of the plate, insert a mounting bolt through the side plate and cane
clamp as shown in FIGURE 1.4.
5. Position the mounting hardware onto the back cane. Perform the following:
A. Ensure the cane clamps are in the OPEN position.
B. Place the mounting hardware against the back cane so that the side plate is on the
inside of the wheelchair.
C. Align the bottom of the side plate mounting slots with the mark on the back cane
made in Determining Personal Back10 Mounting Position on page 10.
6. CLOSE the cane clamps around the back cane and use two (2) cap nuts to secure the
mounting hardware to the back cane. Hand tighten.
7. Repeat STEPS 1-6 to install remaining set of mounting hardware onto the opposite
back cane.
8. Ensure the side plates are mounted to the back canes at the same height and are
parallel to each other.
9. Using the wrench supplied, securely tighten the Personal Back10 mounting hardware.
Back Cane
Cap Nut
Cane Clamps
(OPEN Position)
Cap Nut
Cane Clamps
(OPEN Position)
NOTE: Left back cane shown.
FIGURE 1.4 - INSTALLING THE SIDE PLATES
Personal Back™10 Personal Back™10 Plus
INSIDE OF WHEELCHAIR
Mark
Cane Clamp
Mounting Holes
Mounting Slot(s)
Side Plate Mounting
Side Plate Mounting
Side Plate (Inside)
12
Holes (Upper)
Mounting Bolts
Holes (Lower)
Part No 1114817