3. Install the side plate onto the back cane at the desired depth setting. Refer to Installing
Personal Back10 Mounting Hardware on page 11.
FIGURE 1.6 - ADJUSTING THE PERSONAL BACK10 DEPTH
ADJUSTING THE PERSONAL BACK10 ANGLE
13 - 20-INCH WIDTH
NOTE: For this procedure refer to FIGURE 1.7.
NOTE: If necessary, remove the Personal Back10 from the wheelchair before performing this
procedure. Refer to Installing/Removing The Personal Back10 on page 13.
NOTE: Changes to the mounting pin position and side plate mounting slot will achieve the
following back angles:
1. To adjust the Personal Back10 to the desired back angle, select the appropriate
mounting slot and/or the mounting pin position as shown in FIGURE 1.7.
Part No 1114817
Side Plate
Cane Clamps
Side Plate
(OPEN Position)
Mounting Holes
Cane Clamps
(OPEN Position)
15
SECTION 1—ENGLISH INSTRUCTIONS
DETAIL "A"
Cap Nut
Cap Nut
Side Plate Mounting
Personal Back™10 Personal Back™10 Plus
Back Cane
Side Plate Mounting
Holes (Upper)
Mounting
Bolts
Holes (Lower)