Trimming; Range Check - Multiplex SMART SX FLEXX Notice D'utilisation

Transmitter
3.7
3.8
SMART SX FLEXX
Procedure
Please note: Directly after the transmitter is switched on, the multi-function button is
busy with the activation of the range mode for approx. 5 seconds. After switch-on,
please wait for 5 seconds before switching the Tamiya special function on/off.
1. Move both sticks to the centre position.
2. Press and hold the multi-function button for approx. 3 seconds.
Switch-on is indicated by an ascending tone sequence.
Switch-off is indicated by a descending tone sequence.
The Tamiya mode is switched on by default. The setting is stored permanently for
the respective model.

Trimming

The black (right horizontal) rocker switch is used for trimming the steering with
which the centre position of the servo can be adjusted.

Pressing the rocker switch: one trim increment

Holding the rocker switch: quick trimming
Each trim increment is accompanied by an acoustic signal. Different acoustic
signals are emitted on reaching the trim centre and on reaching the maximum trim
range. The trim setting is stored permanently for the respective model.

Range check

Before starting the model, check the range of the radio control.
Regular range checks are necessary for ensuring the reliable functioning of the
radio control system and for timely detection of changes in transmission properties.
Recommended minimum distance: 50 metres
Procedure
1. Switch on the transmitter.
2. Then, press and hold the multi-function button on the transmitter for approx.
two seconds.
Page 59