Set-Up And Operation - EUROM EK3000 Wall Manuel D'instruction

 Secure the bracket, device and operational panel to the wall according the
diagrams. Check, before hanging the device in the bracket, that it is securely
fastened to the wall. Then secure both M8*37 fixing screws (3) (left and right)
and then both M8*30 setting screws (2). When hanging the holder for the
operational panel, take account of the length of the cable between the device
and operational panel. You are advised to secure the operational panel to the
wall in order to prevent it being dropped, see diagrams 6, 7 and 8.
 Now set the fan angle at the desired position using both setting screws M8*30,
see diagram.
 Make sure the heater is switched off (switch to O position), then plug into a
correctly functioning, properly grounded 230V-50Hz (EK3000) / 400V-50Hz
(EK5000 & EK9000) socket.

Set-up and operation

Please note! When you use the heater for the first time, you may smell smoke. This
is normal and will disappear after a short while. During production, the steel heating
elements are coated with a protective oil and the residues may give off an odour
when heating.
Please note! When the heater stops heating (after being turned off or due to the
thermostat), the fan will continue for a while in order to cool it down. It will stop
automatically after around one minute.
Operating
Set the main switch to 'on' (I pressed); the screen on the remote control will light
-
up.
Press the ON/OFF button on the remote control; 01 starts to flash.
-
Use the ˄ / ˅ buttons to choose the MODE you want to use and confirm this choice
-
by pressing OK:
 MODE 01 = with thermostat and manual output choice
 MODE 02 = with thermostat and automatic output choice
 MODE 03 = with thermostat, weekly timer and always full output
 MODE 04 = with thermostat, weekly timer, automatic output choice and
adaptive start.
35