EUROM EK3000 Wall Manuel D'instruction page 36

If you don't make a choice, the heater will select MODE 01 after 1 minute.

The fan starts to work (symbol
temperature and jumps to the operational safeguard (symbol
You must first unlock (press any button, then press ˄ & ˅ buttons at the same
time – disappears) and then you can continue with MODE 01 (or choose
another MODE).
Please note! If you do not change any settings for 1 minute, the heater will
-
switch to the operational safeguard (symbol
pressing any button and then pressing ˄ & ˅ buttons at the same time; the key
will disappear).
Please note! Only in MODE 03 can day and time be set.
-
MODE 01 = with thermostat and manual output choice
Once you have chosen MODE 01 with OK, the display shows the ambient
-
temperature. The fan begins to blow (fan in the diagram) without heating.
Now choose the desired temperature and output, then the heater will start to heat:
-
 The desired temperature is set with the ˄ & ˅ buttons; the desired temperature
will flash 5 times on the screen, then you will see the ambient temperature
again.
 The desired temperature is set with the SET-button; half power = 1 sun, full
power = 2 suns.
If the set temperature is 2 degrees above the ambient temperature, the heater
-
will heat at the set power.
Once the set temperature is reached, the heating element will turn off; the fan
-
will carry on running for another 60 seconds (cool down).
If the ambient temperature drops up to 2 degrees below the set temperature, the
-
heater will turn on automatically.
MODE 02 = with thermostat and automatic output choice
Same as MODE 01 but the heater chooses the heating output itself:
-
 If it must heat a maximum of 3 degrees: half power
 If it must heat more than 3 degrees: full power
MODE 03 = with thermostat, weekly timer and always full output
Once you have chosen MODE 03 with OK, you must then choose:
-
 03-01 = weekly timer one-off
 03-][ = weekly timer repeated
Use the ˄ & ˅ buttons to choose the desired setting and confirm with OK.
Setting day/time
Now, set the day and time:
-
 Press SET: the day indicator at the top of the screen will flash; use the ˄ & ˅
buttons to choose the current day: (01 = Monday, etc.).
 Press SET again and use the ˄ & ˅ buttons to set the current hour
 Press SET again and use the ˄ & ˅ buttons to set the current minutes
 Confirm by pressing SET again.
The screen will switch between ambient temperature and time, while the arrow at
-
the top points to the current day.
Setting weekly timer
Set the weekly timer:
-
lights up). The screen shows the ambient
lights up); you get rid of this by
in display).
36