EUROM EK3000 Wall Manuel D'instruction page 37

 Press and hold the TIMER button; the screen will show 01 (first timer setting).
Confirm with OK.
 At the top of the screen, the day indication will flash and the screen with show
ON and OFF. You can now choose the day(s) when you'd like to set the timer
01. Use the ˄ & ˅ buttons to switch between ON and OFF; use the TIMER button
to go to the following day. Once all the days are correct, you can confirm with
OK.
 Now the hour setting will flash. On the left, there is the text ON to indicate that
you are setting the time when the heater should work. Use the ˄ & ˅ buttons
to choose the desired hour and confirm with OK. The minute setting will now
flash. Use the ˄ & ˅ buttons to choose the desired minutes and confirm with
OK.
 The hour setting will now flash with the text OFF to the left. Set the time at
which the heater must switch off in the same way and confirm with OK. At the
bottom of the screen, you will see the entered start and stop time and a time
bar.
 Use the ˄ & ˅ buttons to set the desired temperature and confirm with OK.
Time and ambient temperature now flash on the screen.
 The heater will heat at full power for the set period.
 If you'd like to set another timer setting, press and hold the TIMER button. 01
is displayed in the screen. Use the ˄ button to go to 02 (or 03, 04 etc., up to
max. 08) and confirm with OK. Now you can enter a new timer setting in the
same way.
 Please note! The heater will work through all of the settings for a particular
day successively, even if they overlap!
 Please note! If you have chosen 03-01, the heater will work through the set
weekly programme once; if you have chosen 03-][, it will carry on applying the
weekly programme until it is changed.
 Please note! When switching off the heater, it will retain all settings
irrespective of whether you use the ON/OFF switch, the main switch or the
plug. The day and time settings work separately on two long-life batteries
(behind operational panel); when they run out, the day and time settings will
be lost. The heater will then assume, when it is switched on, that it is Monday
at 00.00 and work through the timer settings accordingly (and turn on and off
on the wrong days and times). Make sure that the date and time are set
correctly and, if not, replace the batteries and set the date and time again.
 In order to change the timer settings, set the day to OFF.
MODE 04 = with thermostat, weekly timer, automatic output choice and 20
minute adaptive start
Same as MODE 03 but the heater chooses the heating output itself:
-
 If it must heat a maximum of 3 degrees: half power
 If it must heat more than 3 degrees: full power
Twenty minutes before the set start time, the heater will check the ambient
-
temperature. If it is under the set temperature, the heater will begin to heat and
will choose the output level:
≥ 6 degrees to heat: full power
≥ 3 degrees but ≤ 6 degrees: half power
≤ 3 degrees: no pre-heating.
37