Gardeo GRO24V20PROG Traduction Des Instructions Originales page 53

2.4.Select " " to set 4 numbers start password, screens as below:
---Enter pin code: input original password,
---Enter new pin code: to input new password,
---Confirm new pin: to input new password again.
---When it shows PIN accepted, it means new password
has been accepted, and will return automatically;
---In case the password was input incorrectly, the screen
will show: PIN not accepted. Press
2.5. Set Time & Date screen shows as below:
--- Select Set time to set standard time in user 's country, press
to return.
---Select Set date to set date, press
---Select Set format to set time format as 12 hours or 24 hours, 24 hours will be the
default setting if do not specify. Press
"to return to the main menu , start the mower to work.
2.6. Use"
2.7 Sub-area setting
Sub-area setting is to increase the working efficiency of the mower in large areas.
Also, it helps the mower to go through narrow passages from one area to another. Without this
function, the mower trends to mow the area that near charging station but ignore the one in the
other side of the narrow passage – due to fence line signal problem of the narrow passage, the
mower may not pass.
Divide the lawn into 2~3 small areas and ask the mower to work on each area one by one.
This function must work together with appointment function.
(1) Set Memory Point
---Separate the cutting area into 2~3 small areas according to the picture before
use, then set a memory point in each small area. The memory point will enable the
mower to leave its fence line and enter the certain small area to start mowing.
Put mower on fence wire with a maximum distance of 1 meter from charging station and
make the backside of the mower towards to charging station.
---Input password to show "AUTO" page.
to return the upper menu to reset.
to confirm, press
to confirm, and press
to confirm, press
to return.
to return.