Gardeo GRO24V20PROG Traduction Des Instructions Originales page 51

Note:
 The charger plugs must be well connected to the charging station
and tighten the nuts;
 The battery must be fully charged before first use;
 The two paddles of the charging station are electrified (24V DC).
 T o avoid short circuit, they must never be touched with conductor
when the charger is connected to the charging station.
Operation
Operation Instruction for Robot Mower LED Display Screen
1. Operation of Display Screen
Press the power button"
Press "OK" to enter the operation interface( As per Figure 1):
1.1 Press START to turn on the mower: put the mower on the fence and the mower head is clockwise
to the charge station: ( As per Figure 2):
1.1.1 Put the mower in front of the charging station, distance within 50cm, press "start", when the
extruding poles of the mower touch the paddles of the charging station , the indicator light on the
charging station turn to red, then mower go off the fence and start to mow.
1.1.2 Put the mower at the end of the charging station, press "start", the mower will mow along
the fence line first, and then touch the charging station, the indicator on the charging station turn
to red, mower go off the fence and start to mow.
1.2 Press MENU to set function
1.3 Press HOME to direct the mower back to the charge station
Commonly used in the following situations
1.3.1 To stop the mower during mowing: Press "HOME" to stop, mower will go back to the
charging station. In this condition, the blades stop, and mower go back to charging station for
charging. After fully charged, mower won't start by it self, have to re-start by manual.
1.3.2 To cut the grass on the two sides of the fence line: Turn off the mower, then put the
mower clockwise at the end of the charging station, press "start", the mower will mow along
the fence line first, and then touch the charging station, the indicator on the charging station
turn to red, mower go off the fence and start to mow inside the fence line.
GRASS ALONG THE FENCE LINE)
", the screen shows "ENTER PIN CODE", input initial password (0000)
(TO CUT THE