Functions; Technical Specifications - Gardeo GRO24V20PROG Traduction Des Instructions Originales

d) Check if there are any high-power appliance(such as
transformer, generator,telecommunications tower, ect.) nearby.
Those appliances could interfere the machine signer.
5. The battery is not charging, or the mower does not charge properly, it
bumps the charge station again and again.
a) The extruding poles of the charger are not in contact with the paddles of the
charging station.
b) The extruding poles or the paddles are dirty. Clean them.
(Make sure to disconnect the power before cleaning.)
c) If long time no charge, the left power will be exhausted by itself.
If the battery broken a little you can re-charge many times to
active the battery or you can change the battery.
d) The sensor of the machines is damaged.
6. The mower does not return to the charging station for charging.
a) The fence line is too long. The battery lever is not enough to
return the mower to the charging station. Turn off the mower
and carry it to the station.
b) If the mower was stopped by obstacle it will stop working
7. Subarea function is failure.
Every working area need to set working time.
8. The island can not work.
The island should be circle
9. The mower make a circle in the island and never go to the working
area.
The mower will go around 3 circles, or about 40 seconds, then go to the
working area.
Functions：
A) Select the mowing route intelligently;
B) Avoid collisions intelligently;
C) T ake shelter from rain intelligently;
D) Return to charging station for charging intelligently;
E) Safe protection intelligently.

Technical Specifications

Model
， 。
not square
GRO24V20PROG