Changing A Tyre - Reely 1:10 Monster Truck électrique «Bad 1» 4WD RtR Notice D'emploi

c) Changing a tyre
The tyres are fixed on the wheel rim and cannot be re-
moved. Therefore, if a tyre is worn, the entire wheel must
be replaced.
Loosen the wheel nut (A), and then remove the wheel from
the axle (C).
Attach the new wheel so that the hex socket on the inside
of the wheel rim fits exactly over the wheel hub nut (B).
Screw the wheel to the axle (C) using the wheel nut (A)
that you previously removed. Do not apply any force when
tightening the wheel nut, otherwise the wheel will not spin
freely and the powertrain may be damaged.
When you remove the wheel, the wheel hub nut (B) may accidentally get stuck in the wheel rim or become
detached from the axle (c). Ensure that the drive pin (D) does not fall off.
If the wheel is subsequently re-fitted, it is important to check that the drive pin (D) is inserted exactly into the
centre of the wheel axle (C) and that it is positioned in the corresponding notch on the wheel hub nut (B).
If the drive pin (D) is missing, no torque can be transferred from the motor to the wheel and the wheel will
spin freely.
63