Reely 1:10 Monster Truck électrique «Bad 1» 4WD RtR Notice D'emploi page 56

Function
1 Drive function
2 Motor brake
3 Undervoltage protection
4 Starting mode
5 Maximum braking strength 5x short
The values marked in grey are the preset default values at the time this manual was published. The speed
controller on your vehicle may have different default settings. To determine these settings, refer to the
number of red LED flashes.
Overview of functions:
• Function #1, green LED flashes 1x: Drive function
The speed controller can be switched between the two drive modes ("forwards/brake" and "forwards/brake/re-
verse"). In "forwards/brake" mode, the reverse function can be disabled. This is often required in racing competi-
tions.
• Function #2, green LED flashes 2x: Brake
The vehicle will slow down automatically when you release the throttle on the remote control or move the throttle/
brake lever to the neutral position. The effect is the same as on a "real" car when you release the accelerator pedal
without pushing the brake pedal.
The brake functions like a brake on a standard electric motor (a brushless electric motor does not feature strong
magnets that slow down the rotor).
• Function #3, green LED flashes 3x: Undervoltage protection
When using a LiPo battery, always ensure that undervoltage protection is enabled (we recommend at least 3.0 V
per cell). Failure to do so may cause the LiPo battery to overdischarge and result in permanent damage!
If you are using a 3-cell LiPo battery (approx. 12.6 V when fully charged) with a switch-off voltage of 3.0 V/cell and
the speed controller measures a battery voltage of 9.0 V, the motor will be switched off to prevent the LiPo battery
from overdischarging.
When using a NiMH battery, disable undervoltage protection or set the switch-off voltage to 2.6 V/cell.
If you insert a NiMH battery with a voltage of less than 9 V, the speed controller will mistakenly detect the battery as
a 2-cell LiPo battery when the speed controller is switched on. As a result, the speed controller will switch off when
the battery voltage reaches 5.2 V (2 x 2.6 V). If the voltage of the NiMh battery exceeds 9 V (e.g. in the case of a
fully charged 7 - 9 cell NiMH vehicle battery), the speed controller will detect the battery as a 3-cell LiPo battery.
This would cause the speed controller to switch off at 7.8 V (3 x 2.6 V).
56
Green LED 1x short
flashes
(+beep)
1x short Forward/
Brake
2x short 0%
3x short Switched off 2.6 V/cell 2.8 V/cell 3.0 V/cell 3.2 V/cell 3.4 V/cell
4x short Slow
25%
Red LED flashes.... (+ Beep)
2x short 3x short 4x short
Forward/
Brake/
Reverse
5% 10% 15%
Standard Fast Very fast
50% 75% 100%
1x long 1x long, 1x long,
1x short 2x short
20% 25% 30%
1x long,
3x short
40%