Inserting The Vehicle Battery; Important; Connecting The Vehicle Battery To The Speed Controller - Reely 1:10 Monster Truck électrique «Bad 1» 4WD RtR Notice D'emploi

e) Inserting the vehicle battery
Warning!
Switch on and configure the remote control before connecting the vehicle battery to the speed controller
(see sections 9c and 9d).

Important!

This vehicle is only suitable for use with a 3-cell LiPo vehicle battery (11.1 V rated voltage), a 2-cell LiPo
battery (7.4 V rated voltage) or a 6 - 9 cell NiMH vehicle battery (7.2 - 10.8 V rated voltage).
Using a drive battery with more cells may make the speed controller overheat and cause a fire. In addition,
the powertrain may be damaged due to overload (e.g. differential), which will void the warranty/guarantee!
Check whether the battery has a suitable connector system for the speed controller and that the polarity is
correct (red cable = positive/+, black cable = negative/-).
Loosen the two straps (A) on the battery holder.
Insert the vehicle battery into the battery holder (B).
If the battery connection cable is very short, the battery
must be inserted into the battery holder so that the con-
nection cable points towards the rear of the vehicle.
Pull the straps (A) tight so that the vehicle battery is se-
curely in place, and then secure the straps.
f) Connecting the vehicle battery to the speed controller
Place the vehicle on a suitable support (or a start box) so that the wheels can move freely. This ensures
that you will not lose control of the vehicle if the wheels move suddenly (e.g. if the throttle trim is not set
correctly).
Do not reach into the drive. Do not hold the wheels.
Switch off the speed controller (move the switch to the
"OFF" position). The on/off switch is located between the
speed controller and the receiver box (see right-hand im-
age). The setup button (B) is located next to the on/off
switch (A). This button can be used to program the speed
controller (see section 10).
Switch on the remote control (see sections 9. c and 9. d).
Connect the vehicle battery to the speed controller. En-
sure that the battery is inserted in the correct polarity (red
cable = positive/+, black cable = negative/-).
Do not use force when connect the battery plug to the speed controller. Make sure that the cable cannot get into the
vehicle's drive or into the steering mechanism. If necessary, use cable ties to fasten the cables.
49