Changing A Tyre - Reely Stagger Notice D'emploi

c) Changing a tyre
The tyres are fixed on the wheel rim and cannot be removed. Therefore, if a tyre is worn, the entire wheel must be
replaced.
After loosening the wheel nut (A), pull the wheel off the
wheel axle.
Attach the new wheel so that the hex socket on the inside
of the wheel rim fits exactly over the wheel hub nut .
Screw the wheel tight to the wheel axle with the wheel
nut (A) removed at the beginning. Do not apply any force
when tightening the wheel nut, otherwise the wheel will not
spin freely and the drive may be damaged.
It may be that the wheel hub nut (B) remains in the rim
when the rear wheel is removed or it comes off the wheel
axle (C). Ensure that the drive pin (D) does not fall off.
If the wheel is subsequently re-fitted, it is important to
check that the drive pin (D) is inserted exactly into the
centre of the wheel axle (C) and that it is positioned in the
corresponding notch on the wheel hub nut (B).
If the drive pin (D) is missing, no torque can be transferred
from the engine to the wheel and the wheel will spin freely.
63