Cleaning And Maintenance; General Information; Changing The Crystal - Reely 23 64 20 Notice D'emploi


14.

Cleaning and maintenance

a) General information
Prior to cleaning or servicing, turn the vehicle off and completely separate the rechargeable battery pack
from the drive control. If you have driven the vehicle beforehand, let all parts (e.g. engine, drive control,
etc.) cool down completely first.
Clean the whole vehicle of dust and dirt after driving, use e.g. a long-haired clean brush and a vacuum cleaner.
Compressed air aerosols can also be helpful. Make sure the fan on the speed controller works properly.
Do not use cleaning aerosols or conventional household cleaners. This may damage the electronics and
lead to discolouration on the plastic parts or the body.
A soft, slightly dampened cloth can be used to wipe the car body. Do not rub too firmly to avoid scratch marks.
At certain intervals, perform maintenance work and function controls on the vehicle. This ensures trouble-free operation
and roadworthiness for a long time.
Motor vibrations and shocks during driving can loosen parts and screw fittings. This is why you should check the tight
position of wheel nuts and all screw fittings. The same applies for other parts of the vehicle.
Check whether the wheels are still seated properly on the rims. Due to the high stress on the vehicle, the tyres on this
vehicle are screwed to the rim, a ring on each side of the rim holds the tyre in position.
All ball bearings or gears in the vehicle were lubricated with suitable lubricants by the manufacturer. Relubrication is
normally not necessary.
If worn out or defective vehicle parts must be replaced, use original spare parts only.
Make sure that no cables are pinched or bent or protrude into the drive.
Check the model for damage before each use! If you notice any damages, the vehicle must not be used anymore and
has to be taken out of operation.
b) Changing the crystal
There may be no other transmitter/models with the same frequency in the range of the transmitter, as these transmitters
interfere with each other. As a result, the models no longer respond correctly to the transmitter commands. If there are
other model vehicles in your range, talk to the other operators about the frequencies they use.
Only use suitable accessory crystals for the transmitter and the receiver.
Prior to a quartz change, first turn off the vehicle and then the transmitter.
The transmitter crystals are labelled "T" or "TX", the receiver crystal is marked "R" or "RX" . Do not mix up these
crystals. Otherwise the vehicle will no longer function correctly.
42