V- Setting The Temperature; Vi- Silent Function - Eurocave INOA Série Mode D'emploi

7 - C
OMMISSIONING YOUR CONDITIONER
If you wish to reprogramme the remote control for an internal sensor, disconnect the wired sensor and reprogramme the remote control in internal mode
(IN) by repeating the first two steps described in the paragraph above (see 5-III-b p.11):
The 2nd screen displays
Then repeat the same steps, as indicated in the above paragraph (see 5-III-b)
c- Fitting
- Fit the remote control and sensor using the screws and pegs supplied.
- Place the sensor inside the cellar.
- Place the sensor as close as possible to the bottles
N.B.: the sensor has a range of 3 metres.
Cellar
temperature
display
Temperature
indicator
Cellar temperature
setting keys
Press the key to confirm the new setting, the display then returns to the new setting.
The setting can be adjusted between 9 and 15°C. Beyond this range, the
WARNING: to operate correctly, your conditioner must be in a location where the ambient
temperature is between -5°C is 35°C.
When making significant modifications to temperature settings, it can take several hours for the temperature in your cellar to stabilise and for the conditioner
to display the desired temperature.

VI- Silent function

Your EuroCave conditioner is fitted with a silent function which allows the sound level to be reduced when you enter the cellar.
When the conditioner is on:
- Press and hold down the key for 3 seconds.
The display then appears. Next the current temperature is displayed.
You will be able to see this function via the
The compressor then remains in operation and the fans change to slow speed for 15 minutes.
After this, the conditioner returns to the default operating speed.
indicating OUT (OUT= external installation). Press the
Selection and confirmation key
pictogram which flashes for 15 minutes.
key to change to IN internal mode. Press

V- Setting the temperature

Setting the temperature of your conditioner is carried out
entirely from the remote control which has the following
layout:
Temperature
- Temperature display: displays the actual temperature inside
units (according
your cellar.
to the country)
- Setting keys: allow you to select the desired temperature
inside the cellar.
To adjust the temperature:
- Press then immediately release the
The setting then appears (the temperature flashes).
- When the temperature flashes, you have 7 seconds to
change the setting by pressing the
otherwise the display automatically returns to the previous
setting.
The recommended setting range for maturing wine: 10 to
14°C.
and keys do not work.
to confirm.
key.
or keys,
11
GB