Commissioning Your Wine Cabinet; Connection And Starting Up; Description (1 Temperature Model V-Prem-S, V-Prem-M, V-Prem-L); Temperature Setting - Eurocave Compact Mode D'emploi

6 - c

1. Connection and starting up

Wait 48 hours before plugging in your wine cabinet.
•
By default, the control unit is in the on position. To place the wine
cabinet on standby, press and hold down the
seconds.
•
The display switches from the inside temperature to the OFF display
(the wine cabinet is no longer operating, only the display is activated).
•
To relaunch the wine cabinet control, press and hold down the
button for several seconds until only the temperature is displayed.
II. Description
1
2
3
4
III. Temperature setting
The temperature of your wine cabinet is set exclusively from the control
panel.
1
Press and hold down the SET key for approximately 5 secs until the
set temperature (ST1) flashes.
The default temperature setting is 12°C (ideal wine maturing
temperature). However, the temperature can be set from 9°C - 15°C.
The recommended setting range for storage is 10°C - 14°C.
2
Set the desired temperature using the
12
GB
ommissioning your Wine cABinet
button for several
5 sec.
and .
Have your plug checked (presence of fuses, amps and 30 mA
circuit breaker).
Do not plug several cabinet into a multi-socket.
1
Compressor: indicates that the compressor is in operation. When
it flashes, it means that the compressor is going to start in the next
few minutes (time required to perform action).
2
Defrosting cycle: indicates that an automatic defrosting cycle is
underway.
3
Heater: indicates that the heater is in operation.
4
Alarm: indicates an abnormally high or low temperature inside the
wine cabinet.
3
Confirm your programming by pressing the SET button. If you do not
confirm your setting using this key, your modification will not be taken
into account.
The value shown on the display is the actual temperature inside
the cabinet. It is therefore necessary to wait before your new
setting takes effect.
Alarms
If the temperature inside the cabinet is 6°C above or below the
temperature setting, for over 18 hrs, the control activates the
visual and audible alarm: the
SET button to stop the alarm.
NB : If you have loaded your cabinet with a large number of bottles, it
can take several days for your wine cabinet's temperature to stabilise. The
alarm may then sound and the
while then check again. If the alarm still sound and the alarm warning light
does not disappear, contact your retailer.
Warning: to function correctly, your cabinet must be placed in a room
with a temperature of 0 - 35 °C / 32 - 95°F.
warning light appears. Press the
warning light may then appear. Wait a