Iv- Installing The Remote Control - Eurocave INOA Série Mode D'emploi

7 - C

IV- Installing the remote control

You can install the remote control inside your cellar.
We recommend that you place it as close as possible to the bottles.
Fix the unit close to your bottles using the supplied pegs and screws (see diagram below)
N.B.: Do not place the remote control in the path of the conditioner's cold air flow.
Installing the remote control outside the cellar
It is also possible to place the remote control outside the cellar.
In this case, it is essential to connect a sensor (supplied with the appliance) to the remote control before installing it.
a- Connecting the sensor to the remote control
- On the back of the remote control, push the 2 batteries downwards using a screwdriver (diagram 1).
- Remove the central knob, unscrew the screw with a small screwdriver and open the unit (diagram 2)
- On the back, connect the sensor's 2 wires (blue and red) to the circuit connector using a small flat screwdriver (diagram 3).
You can connect either the blue wire or the red wire to the circuit connector.
Pass the wires through the recess on the top of the unit.
- Close the unit, ensuring that the wires pass through the recess and are not jammed
- Rescrew and replace the central knob
- Replace the batteries. One in use and the other as a spare with plastic insulator
b- Programming the remote control
Where placing the remote control outside the cellar, having connected the external sensor, it is essential to reprogramme the unit
- To turn on the remote control, press and hold down the
- First press and continuously hold down the
appear.The model number is then displayed and flashes.
- Press .
- The screen appears indicating IN (IN= internal installation). Press the
- The display appears indicating OUT (OUT= external installation). Press
- The pictogram appears. Press
- The screen appears. Press
- The pictogram appears. Press
- .appears. Press
- The pictogram appears. Press
- The screen appears, then
10
OMMISSIONING YOUR CONDITIONER
1
key for about 8 seconds until the
key, at the same time press and continuously hold down the
.
.
.
.
.
.
indicator goes off.
.
key to change to OUT external mode.
to confirm.
2 3
key for several seconds until three lines