Onditioner Operation - Eurocave INOA Série Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

5 - I

• Fitting: (see C diagrams)

Your conditioner comes supplied with a metal mounting frame

which simplifies the process of drilling air entry and exit holes.

It also has 2 extendable ducts to be cut to length (75 cm each) in

order to install the conditioner whatever the thickness of the wall.

Finally, your conditioner is supplied with an aesthetic front panel and

4 grids for an aesthetic appearance.

• Recommendations:

- Fit your conditioner as close as possible to the ceiling in order to ensure uniform dispersal of cold air in

the cellar.

- We recommend that you leave a space of 200 mm between the ceiling and your conditioner to make it

easier to fit the appliance on its base.

- The air outlets (hot and cold) must not be obstructed by any obstacle (minimum distance: 1500 mm).

Direct the cold air outlet so it is facing the bottles (see diagram D).

The installation (wall drilling and fitting) of your conditioner must be carried out by a EuroCave approved

fitter.

6 - C

The INOA conditioner is fitted with a refrigerating unit:

• an evaporator forces cold air inside the room,

• a condenser expels the hot air outside.

The evaporator fan operates continuously to ensure that air is

constantly mixed and that temperatures are as uniform as

possible, in accordance with speeds automatically adjusted

according to requirements.

NSTALLING YOUR CONDITIONER