Iii- Description Of Control Panel; On/Off Button; Iv- Temperature Setting - Eurocave V101 Mode D'emploi

Gamme première
Masquer les pouces Voir aussi pour V101:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
7 - C
III - Description of control panel
Temperature display
IV - Temperature setting
Setting the temperature of your wine cabinet is carried out on the control panel inside.
• Temperature display: Displays the current temperature inside your wine cabinet.
• Adjustment buttons (
/
• Confirmation button "P": confirm the setting temperature.
• On/off button: "U" switches the wine cabinet on and off.
To adjust the temperature of your cabinet:
• Press and hold down the
• Set the desired temperature by pressing the
• Confirm your programming by pressing and holding down the "P" button for a few seconds.
Your programming will be automatically confirmed if no button is pressed within the 15 seconds following programming.
The recommended control range for preserving and maturing your wine is from
9°C/48°F to 15°C/59°F, the default setting is 12°C/54°F.
To operate correctly, your cabinet should be located in a room with a temperature
between 0°C/32°F and 35°C/95°F.
When there has been a significant modification in set temperatures, it can take several hours for your wine cabinet to stabilise and display the desired
temperature.
For optimal performance, we recommend that you fill your cabinet to at least 75% of its capacity.
You have loaded your cabinet with a large number of bottles: it takes several hours for your cabinet to reach the right temperature.This could happen when
first starting up the cabinet, this is not due to an operating fault.
If, however, after a few days, the problem persists, contact your EuroCave (or Around Wine) dealer.
N.B: Only prolonged exposure to excessive temperatures or violent fluctuations in temperature will harm your fine 'crus'.
OMMISSIONING YOUR WINE CABINET

On/Off button

) set the desired temperature inside the cabinet.
button for a few seconds.The symbol "SPI" will appear alternatively with the previous temperature setting.
and
buttons.
Confirmation boutton
Adjustment buttons
11
EN

Publicité

Table des Matières
loading

Table des Matières