Sulky TRAMLINE SE Notice Originale page 19

Mise en route / Start-up / Inbetriebsetzung
D
Tractor control
- To be checked :
• The total authorised weight.
• The permitted weight per axle.
• The authorised support weight on the tractor's linkage.
• The permissible load capacity for the tyres fitted to the tractor.
• Is the authorised linkage weight sufficient?
All of this information can be found on the registration papers, or on the data plate and in the tractor manual.
Figures that you should know
P Kg Unladen weight of tractor
P1 Kg
Weight on the front axle when the tractor is empty
P2 Kg
Weight on the rear axle when the tractor is empty
M2 Kg Total weight with machine attached to rear
m1 Kg Total weight of front ballast
Distance between the centre of gravity of the front
m
a
ballast and the centre of the front axle
m
Wheelbase of tractor
b
Distance between the lower linkage pins and the
m
c
centre of the rear axle.
Distance between the lower linkage pins and the
m
d
centre of gravity of the machine.
M1 mini = Calculation of the minimum ballast need in front.
P1c = Calculation of the weight on the front axle
Pc = Calculation of the total weight of the unit (tractor + machine)
P2c = Calculation of the weight on the rear axle
v
alueS calculated
P1
c
P2
c
P
c
- Complete the table below:
- Check that:
• The values calculated should be
• It is essential that the minimum load on the front axle is > or = to 20% of the unladen tractor weight.
The machine must not be hitched to a tractor if :
The total weight calculated is > than the maximum authorised weight.
The weight on the front axle is
t
ractor
‹
or = to the tractor's permissible values and the values for the tyres fitted to the tractor.
‹
than the minimum required.
Consult the tractor's instruction manual or the regis-
tration documents.
Consult the machine's technical characteristics. (see
section "Characteristics").
Consult the technical characteristics of the tractor and
the front ballast, or measure.
Consult the instruction manual or the tractor's regis-
tration documents, or measure.
Consult the machine's technical characteristics. (see
section "Characteristics").
v
alueS PermiSSible with the tyreS that are
'
S PermiSSible valueS
EN
Fitted to the tractor
1
19