Important:
– only use the appliance to cook food;
– before cleaning or maintenance or in case of malfunction, disconnect the appliance from the power supply;
– use oven gloves when placing containers in the oven or removing them;
– since the end of the door handle may be hotter due to exiting hot air, always grip it in the middle;
– always make sure the control knobs are in the off position when the oven is not in use;
– if the oven is no longer to be used, disconnect it from the power supply.
Installation (Fig. 4)
Important: Installation must comply with the current standards and regulations. It must be only be carried out by
specialised and licensed personnel.
Cabinet requirements
For fitted units, the components (plastic materials and veneered wood) must be assembled with heat-resistant adhesives
(max. 100 °C): unsuitable materials and adhesives can result in warping and ungluing. The cabinet must allow sufficient
room for the electrical connections. The cabinet in which the oven in fitted must be strong enough to take the weight of
the equipment.
The oven must be securely installed in the recess. The oven can be installed in a column cabinet or under the top of
a modular unit, provided sufficient ventilation is guaranteed.
Installation instructions
Fit the appliance in the compartment; fix the body to the cabinet with the 4 screws provided, using the holes prepared
in the sides.
Use the 4 bushes provided as well as the 4 screws (Fig. 5a).
If the oven is to be fitted under a cooktop, firstly turn the top connection (R) to the right or left so that the oven fits
properly (Fig. 5b).
Electrical connection
FRANKE ovens are supplied with a three-core power cable with free terminals.
If the oven is permanently connected to the power supply, install a device that ensures
disconnection from the power supply, with a contact opening distance enabling complete
disconnection in category III overvoltage conditions. Make sure:
a) the plug and socket are suitable for a 16 A current;
b) both can be easily reached and are positioned so that no live part is accessible when inserting
or removing the plug;
c) the plug can be easily inserted;
d) the oven does not rest against the plug when installed in the cabinet;
e) the terminals of two appliances are not connected to the same plug;
2
f) a 3 x 1.5 mm
H05VV-F type cable is used when replacing the power cable;
g) the connection polarities of the free terminals are respected (Brown=Line Blue=Neutral
Yellow/Green=Earth).
NB: Make sure the characteristics of the household electrical system (voltage, maximum power and current)
are compatible with those of your FRANKE oven.
Note: The mains frequency is established at switching on. When the timer is connected to 60 Hz, the symbol P
flashes at startup.
GB
BLUE
YELLOW-GREEN
BROWN
19