Franke SG 62 M Mode D'emploi Et Installation page 16

Delayed start of cooking with set duration
When the time of the day is displayed, press the Mode or Set button twice to set duration, then press it again to set the
end cooking time. Set the required time with the + and – buttons. During the selection of duration or end time
adjustment mode, the Auto symbol remains lit.
Once a programme duration is set, the end time cannot be decreased. Likewise, the duration of a programme cannot be GB
prolonged once the end time is set.
The end time and duration settings define programme start time as follows:
start time = end time - duration.
After setting the duration and end time, the display still shows the end time. The programme starts when the time of day
coincides with the start time: the Auto symbol lights up fixed and the symbol lights up flashing. After the start of
cooking, the display shows the countdown. If only the end time is selected (the duration is = 0), cooking starts and the
display shows the countdown.
The Auto symbol remains lit during the wait for delayed start and for the entire duration of cooking.
The symbol flashes during the wait for delayed start and remains fixed when cooking starts.
An acoustic signal sounds at the end of cooking; to silence it, press any button or allow the signal to continue
for its duration.
Semiautomatic programme with duration or end time
Programme time setting
To select the programme duration or end time press the Mode or Set button twice and set the required time with the
+ and – buttons. During duration or end-time adjustment mode selection, the corresponding Auto symbol flashes.
Once a programme duration is set, the end time cannot be decreased. Likewise, the duration of a programme cannot be
prolonged once the end time is set.
Programme run
When the automatic programme is in progress, the Auto symbol remains lit and the time of day appears on the display.
Also the symbol remains lit.
Automatic programme end
At the end of the programme duration or when the end time is reached, the corresponding symbol goes off. At the
end of the automatic programme, the "Auto" symbol flashes, the display shows "End" and an intermittent acoustic signal
(which can be stopped by pressing any button) sounds.
Timer function
The timer allows the setting of a time from which a countdown begins. This function does not switch the oven on or off,
but only sounds an audible alarm when the time has elapsed.
Press the Mode or Set button once; the display shows:
The bell symbol flashes then the alarm duration can be set with the + and – buttons. When this function is active,
the bell symbol remains lit and the display shows the remaining time (countdown).
At the end of the time an acoustic signal (which can be stopped by pressing any button) sounds.
Modifying/deleting data
• The set data can be changed at any time by pressing the + and – buttons together.
• Cancelling the cooking duration automatically ends the function, and vice versa.
• In case of programmed operation, the appliance will not accept end of cooking times prior to those of start of
cooking proposed by the appliance itself.
NB: The oven stays hot at around the set cooking temperature for a long time after it has been switched off; therefore
to avoid overcooking or burning the food, it is advisable to remove it from the oven.
15