Computer - PowerPeak FTM8317P Mode D'emploi

COMPUTER
Display
PULSE / CALORIES: shows the calories and the heartbeat frequency. When the calories have reached 999,
the display will count from 0 again. When you have set the calories, the computer will count down to 0.
After reaching 0, the treadmill will stop slowly and the display shows 'END'. When the user holds the
hand pulse sensors for more than 5 seconds, the display will show the heartbeat frequency (50 – 200
heartbeats per minute).
TIME / DISTANCE: shows the time (0:00 – 99:59) and the distance (0:99,9), display switches between
these two values. As soon as time has reached 99:59, the treadmill will slowly stop. When you have set
the time, the computer will count down to 0:00. After reaching 0:00, the treadmill will stop slowly and
the display shows 'END'.
As soon as distance reaches 99,9, the treadmill will slowly stop. When you have set the distance, the
computer will count down to 0. After reaching 0, the treadmill will stop slowly and the display shows
'END'.
SPEED: shows the speed (1,0 – 16 km/h).
Buttons
PROGRAM: when in standby mode, this button is for choosing a program: 0:00 (manual program), P1 to
P12 (pre‐set programs), FAT (body fat program).
MODE: this button is to switch between the different options: 0:00 (manual operation), 15:00 (time
countdown), 1,0 (distance countdown) or 50 (calories countdown). Use the SPEED+ or SPEED‐ button to
modify the settings. Then press START to start the treadmill.
START: when the device is switched on and the safety key is attached, press this button to start the
treadmill.
STOP: if you push this button while running, the treadmill will slowly stop. The speed will decline until
the treadmill has come to complete stand still.
29