PowerPeak FTM8317P Mode D'emploi page 23

• Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
• Never leave the treadmill unattended while it is running. Always remove the safety key and move
the on/off switch to the OFF position when the treadmill is not in use.
• When folding or moving the treadmill, make sure that the safety lock is fully engaged.
• Always unplug the power cord before performing the maintenance and adjustment procedures
described in this manual. Do not remove the motor cover unless instructed to do so by an
authorized service representative. Servicing other than the procedures in this manual should be
performed by an authorized service representative only.
• Keep the plug and power cord away from hot surfaces.
• To disconnect, turn the power switch to the OFF position before removing the power plug from the
wall socket.
• Keep all electrical components, such as the motor, power cord and on/off switch away from water or
other liquids to prevent shock. Do not place anything on the handrail, computer console or belt.
Never place liquids on any parts of the unit.
• Always insert the safety key and attach the clip to your clothing at your waist before starting your
workout. If you encounter problems and need to stop the motor quickly, simply pull the cord to
disengage the safety key from the console. To get off the treadmill, wait until the belt has stopped
moving, then step onto the side platforms and on to the floor. To continue operation simply reinsert
the safety key into the console.
• Keep all loose clothing and towels away from the running surface. Do not wear loose clothing and tie
back long hair. The belt will not stop immediately if an object becomes caught in the rollers or belt.
Should an object become caught, turn the unit off immediately.
• Proceed with caution when getting on or off the treadmill. Use the handrails whenever possible.
Only step onto the running surface when it is running at a very slow speed. Do not step off the
treadmill while the belt is moving.
• To get on or off the running surface, straddle the running surface by standing on the right and left
plastic platforms on each side of the belt.
• Never attempt to turn around while on the treadmill with the belt running. Keep your head and
body facing forward at all times.
• Do not rock the treadmill, stand on the handrails or computer console at any time.
• To reduce the risk of personal injury, there must be sufficient space behind the treadmill.
• This device requires a regular check‐up to prevent physical injury. This means that bolts and nuts
should be frequently checked for cracks and sharp edges etc.
• Defective components must be replaced immediately. If this is not possible, the device must be put
out of order until the necessary repairs have been made.
Electrical safety
This motorised treadmill must be grounded. Should it break or malfunction, grounding reduces the risk
of shock. The treadmill is equipped with a power cord with grounding conductor and an earth
connection in the plug. The plug must be inserted into an appropriate outlet that is properly installed
and grounded in accordance with all local codes and ordinance.
Important
There is risk of electric shock if the grounding conductor is not properly connected. If you doubt whether
this treadmill is earthed in the correct manner, please contact our service department. Do not change
the power cord or plug.
23