Lenze 8200 motec Instructions De Montage page 78

2 Safety instructions
General safety information
Commissioning
ƒ If required, you have to equip the system with additional monitoring and
protective devices in accordance with the respective valid safety regulations (e. g.
law on technical equipment, regulations for the prevention of accidents).
ƒ Before commissioning remove transport locking devices and keep them for later
transports.
Operation
ƒ Keep all protective covers and doors closed during operation.
Maintenance and servicing
ƒ The components are maintenance−free if the required operating conditions are
observed.
ƒ If the cooling air is polluted, the cooling surfaces may be contaminated or the air
vents may be blocked. Under these operating conditions, the cooling surfaces and
air vents must be cleaned at regular intervals. Never use sharp objects for this
purpose!
ƒ After the system has been disconnected from the supply voltage, live components
and power connections must not be touched immediately because capacitors may
be charged. Please observe the corresponding notes on the device.
Disposal
ƒ Recycle metals and plastic materials. Ensure professional disposal of assembled
PCBs.
78
l
EDK82MV371 DE/EN/FR 7.0