Operating The Sg7 Conductivity Meter; The Display - Mettler Toledo SevenGo pro SG7 Mode D'emploi

Operation
4.

Operating the SG7 conductivity meter

4.1

The display

1 Battery status shows the condition of the batteries, fully charged, half-charged or fully discharged.
(To replace batteries see Section 3.1)
2 Auto-off override, in default operation, the meter switches itself off after 15 minutes to prolong battery
life. After switching off/on the auto-off is active again
3 IrDA infrared interface, for data transfer to printer or PC (See section 4.7)
4 GLP print-out is acitvated (See end of section 4.6)
5 Data Logging, timed interval reading is active, data is transferred to memory at a user-defined interval
6 Backlighting, meter switches on backlighting when any key is pressed
7 Calibration reminder, the frame blinks when the calibration reminder is on and a calibration is due
8 Conductivity/TDS/salinity/resistivity reading
9 Temperature
10 Dot matrix area
8
1 2
8
7 9
10
3 4 5 6
METTLER TOLEDO SevenGo pro™ conductivity
7