Blade Guides Adjustment; Setup And Adjustments - Promac 349V Mode D'emploi

Masquer les pouces Voir aussi pour 349V:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The machine is designed to cut in dry condition only.
The use of any coolant or oil will damage the machine.
Don't cut magnesium-
high danger to fire!
Support long workpieces with helping roller stands.
Work only with a sharp and flawless saw blade.
Don't take measurements when the machine is running
Don't chuck too short in vice.

7. Setup and adjustments

General note:
Setup and adjustment work may only be carried out
after the machine is protected against accidental
starting by pulling the mains plug.
7.1 Mitre angle adjustment
Mitre cuts can be made from 0° to 60°.
The 90° stop has been adjusted ex works.
To make mitre adjustments:
Loosen the clamping lever (A, fig 4).
Set the saw arm to the desired cutting position (scale).
Retighten the clamping lever (A).
Fig 3

7.2 Blade guides adjustment

Loosen the indexable knob (B, Fig 5) and slide blade guide
assembly (C) as close as possible without interfering the
material being cut. Tighten knob.
7.3 Machine vice adjustment
The machine is equipped with a vise.
Fig 4
Fig 5
Fig 6

Publicité

Table des Matières
loading

Table des Matières