Anti-Theft Locking Device; Warm-Up Time; Accessing The Scale Via The Network; Connecting To A Network With Dhcp - Sartorius PMA.Vision VIS1X Notice D'installation

t
t
t
y
Removing/Replacing the Mains
Adapter
t
t
Power Connection/Safety Precautions
− Only use original Sartorius power supplies.
The power supply has an IP rating of IP40 in accordance
with EN60529/IEC60529.
− Make sure that the voltage rating printed on this unit
matches the voltage at the place of installation.
− If the stated supply voltage or the plug design of the
power supply does not comply with your country's
standard, please inform your nearest Sartorius
representative.
− The power must be connected in accordance with the
regulations applicable in your country.
Connection to the Power Supply
t
2
t
t
8 Installation Instructions VIS1X
Insert the power plug adapter
into the power supply. The
grooved button must be facing
upwards.
Push the power plug adapter as
far as you can until it clicks into
place.
Check whether the power plug
adapter is securely locked in
place by pulling it gently.
If the power plug adapter does
not move, it is locked in place.
Press the grooved button from
above and pull back on the
mains adapter.
Push the power plug adapter
out of the power supply and
remove it.
Insert a USB cable (2) into the
ex-link converter.
Insert the USB cable into the
YEPS01-USB power supply.
Plug the power supply into a
wall outlet (supply voltage).
3.7

Anti-Theft Locking Device

t
3.8

Warm-up Time

To ensure accurate results are
0
delivered, the scale must warm up
for at least 30 minutes after initial
connection to the power supply.
Only then will the device have
reached the required operating
30
temperature.
4 Accessing the Scale via
the Network
4.1

Connecting to a Network with DHCP

Usually, the IP address on a network is assigned by a DHCP
server (Dynamic Host Configuration Protocol). A prerequisite
for this is that DHCP mode is enabled on the scale.
Press the i button to call up the "Settings" menu.
t
Go into the submenu "Ethernet."
t
If the display says "DHCP (On)," the settings are correct.
If required, secure the scale at
the back.