7.
insTallaTiOn
7.1.
safety information
Danger!
hazard due to electrical voltage!
Intervention in the device poses an acute risk of injury.
• Always switch off the power and secure it to prevent restarting
before removing the cover, or using the lever.
• Always connect multiple rotary actuators with phase isolation via
a switch!
• Protect electrical rotary actuators by using a mains-dependent
safety!
• Observe all applicable accident protection and safety guidelines
for electrical equipment!
Warning!
hazard due to improper installation!
Incorrect installation can result in personal injury and in damage to
the device and its surroundings.
• Installation may only be carried out by authorised technicians
using appropriate tools!
• Pay attention to the information in chapter „6. Technical Data".
• Before installation, ensure that the manual lever can move freely.
14
english
Type 3003
Installation
Warning!
danger due to unintentional activation of the device!
Unintended actuation of the device during installation can lead to
injury and damage to property.
• Take appropriate measures to prevent the possibility of uninten-
tional activation of the device.
7.2.
power and control connections
work steps:
→
Disconnect the rotary actuator from the power supply.
→
Remove the position indicator from the axis.
→
Loosen the cover screws with a screwdriver and lift the cover off.
→
Disconnect the cable connector ISO20 and insert the cable.
→
Wire the connections according to the circuit diagram figures (see
„6.5.3. Electrical circuit diagrams").
Use cables with a diameter of 7 ... 12 mm for the ISO20
cable fitting.
→
Set the cover in place and screw it tight.
→
Reinstall the position indicator.