Spypoint TINY-WBF Manuel D'utilisation page 8

14
PROGRAMMING
Turn on the camera to navigate in the interface by pressing
 or  and press OK for selection. To modify the selection,
press  and  again and press OK to confirm. To return to
the previous menu press .
PHOTO
To take pictures. The PHOTO mode must be selected by
pressing OK; the test light in front of the camera will blink
for 60 seconds to allow the operator to walk away from the
camera without being recorded.
VIDEO
To take videos. The VIDEO mode must be selected by
pressing OK; the test light in front of the camera will blink
for 60 seconds to allow the operator to walk away from the
camera without being recorded.
SPY SPY P P INT INT
TINY-W BF
Test Light
TEST
To set the camera or the distance. When TEST mode
is selected, no picture or video is recorded. Walk
perpendicularly in front of the camera. When the camera
detects movement, the light blinks to indicate that normally,
a photo or video would have been recorded. If the system
does not detect the movement, increase the distance detection
using the SETTINGS menu (the option "SENSITIVITY"
allows the user to set the sensitivity to "HIGH", "MEDIUM
"or "LOW"). You can also realign the camera differently.
Once you understand how the device responds to detections,
you can better adjust the direction or the height of the camera
How to properly install your camera
using the supplied installation strap:
(Recommended installation height: about 3 feet).
In TEST mode, it is possible to take a picture by pressing
the OK button. The photo is saved and appears in VIEW
mode.
15