Spypoint TINY-WBF Manuel D'utilisation page 5

8
1. Power button
2. LED recording indicator
3. UP button
4. BACK button
5. OK button
6. DOWN button
7. ALK / RECH (switch for battery)
8. SD card slot
9. USB port
10. 12-volt / Solar panel jack
11. External trigger jack
12. TV OUT
13. Removable battery case
14. Microphone
POWER (TINY-W
The battery level is shown in the bottom right corner of the
screen when the camera is in TEST mode. When a single
line remains, the camera will continue to take pictures but we
strongly recommend changing the batteries before they are
empty. (See figure below)
CAMERA)
BF
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
Also note that the voltage of rechargeable AA batteries
(1.2V) is insufficient to power this camera. During the
installation of the alkaline batteries, slide the switch inside
the battery case to ALK. Insert the batteries in the battery
case as indicated and insert it inside the camera (see figure
below). Exact polarity must be followed. We also recommend
the use of new batteries to ensure maximum performance of
your camera.
Lithium battery pack
This camera can be powered by a rechargeable lithium battery
pack LIT-09/LIT-C-8 (sold separately, see OPTIONS). This
type of battery is less affected by cold temperatures and
lasts up to 3 times longer than alkaline batteries. During the
installation of the lithium battery pack, slide the switch inside
the battery case to RECH. Insert the battery in the case as
indicated and insert it inside the camera (see figure below)
Connectors
Top
6 x AA
Top
SPY SPY P P INT INT
TM
Lithium battery pack (LIT-09)
9