Spypoint TINY-WBF Manuel D'utilisation page 9

16
SIGNAL
Wireless signal test
The quality of the wireless signal between the TINY-W
camera and the BLACKBOX
the camera in "SIGNAL" mode by choosing the "RANGE
TEST" option. If the icon of the wireless signal is red, the
signal is too weak. Bring closer or move the receiver. If
the icon of the wireless signal is green and stays green for
at least 10 seconds, the signal is strong and stable enough
to enable wireless transmission of images to the receiver.
For best results, the antennas of the two devices must
point upwards and their respective height should be
approximately the same.
Note: To see the wireless signal icon on the main menu, the
"Transmission" option in SETTINGS should be "On" "
Note: If the receiver is not powered and synchronized with
the camera , the signal icon remains red.
Manually synchronizing one or multiple sets (TINY-W
camera + BLACKBOX
Note: By default, the camera is synchronized with its
receiver on channel 1 and the icon SYNC is green. If you
want to change the synchronization channel or to add other
sets (TINY-W BF camera + BLACKBOX
same area, refer to the following procedure.
TM receiver can be checked on
TM receiver) in the same perimeter
TM receiver) in the
+
When more than one TINY-W
the same area of transmission, it is necessary to manually
synchronize each camera with its receiver on a different
channel. To do so:
BF
1. Turn on the first camera and choose the "SIGNAL" mode.
2. Turn on the first receiver.
3. Choose the "CHANNEL" option on the camera and press
OK.
4. Use the  and  buttons to select a channel and press OK.
5. Choose the "SYNC" option on the camera and press
OK. The camera synchronizes with the powered receiver
and the icon "Sync" goes from red to green when the
synchronization is complete.
6. Turn off the camera and the corresponding receiver.
7. Repeat these steps for each additional camera, up to 9
devices can be paired in the same area.
Note: In the minute following turning on the receiver, the
first 8 seconds allows you to know the battery status by the
test light (see POWER (BLACKBOX
Then, for the rest of the time, the test light flashes rapidly to
BF
indicate the synchronization period.
Note:After a synchronization or when the test light turns off
(after 60 seconds), the receiver can't be synchronized unless
it is turned off and on again.
BF cameras are located in
TM Receiver) section).
17