Spypoint TINY-WBF Manuel D'utilisation page 10

Masquer les pouces Voir aussi pour TINY-WBF:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

18
SETTINGS
To define the options of the camera. To configure the
system in English, hold the button  until "LANGUAGE" is
highlighted. Press OK, select "ENGLISH" and confirm your
choice with OK. The system will change all the menus to
English.
Time Start /
Allow the user to set the period of operation
Time Stop:
of the camera. The start and stop time are
the hours during the camera is in action and
records pictures or videos. Example: if the
user selects a start time "7:00 am" and a
stop time "11:00 am", the camera will only
detect for that period of time and will stay
inactive for the remaining hours. Press OK
and use  or  to adjust the hour.
Press OK again to set the minutes. When the
time is properly set, press OK once more to
go back to other settings. For an activation
of 24 hours, the same start and stop time
must be entered (example: 00:00 as start
time and 00:00 as stop time. These hours
are the basic settings of your camera)
Note: The hours can be recorded over a 12
or 24 hours period. Refer to SETTINGS/
TIME FORMAT (00:00 means midnight)
Enables or disables the wireless transmission
Transmission:
(On/Off)
of images to the BLACKBOX
When the transmission is enabled:
• Only pictures are transmitted to the
receiver, not videos.
• The quality of the photos on the receiver
is reduced to maximize transmission:
8MP = 800 x 600 pixels
5MP = 640 x 480 pixels
3MP = 320 x 240 pixels
• When in TIME-LAPSE mode, photos
are sent to the receiver except for the
"30s" setting.
• When the delay setting "10s" is selected,
the time between each detection is
calculated
is completed. For example, if the
transmission takes two seconds, the
time between the two detections is 12
seconds.
Delay:
Select the time interval between photos or
(10s/1m/3m/5m/
videos.
10m/15m/30m)
Additional setting: it is possible to reduce
the delay between detections to 10 seconds
(instead of 1 minute) by using the following
procedure. Note that the battery life will
be affected.
receiver.
TM
when
the
transmission
19

Publicité

Table des Matières
loading

Table des Matières