Dometic MS660 Instructions De Montage Et De Service page 51

MS660
11.9 Setting workshop mode
You can set the alarm to the so-called workshop mode if, for example, the vehicle is
to be handed over for inspection or repairs. In workshop mode, all settings for the
alarm system remain stored, even if the battery is disconnected.
To do this, proceed as follows:
➤ Deactivate the alarm system.
➤ Close all the doors.
➤ Switch on the ignition.
➤ Press the "Lock" button three times within 5 sec.
✓ Workshop mode is switched on.
✓ The indicators light up once to confirm.
Switching off workshop mode
➤ Press the "Lock" button.
✓ Workshop mode is switched off.
✓ The indicators light up once to confirm and the central locking opens.
11.10 Using the panic mode
The alarm system has a panic mode. You can trigger the alarm by hand-held
transmitter, for example, to scare off an assailant if you are attacked. For this function,
the ignition must be switched off and the alarm system in activated mode.
To activate the panic mode, proceed as follows:
➤ Press the "Lock" button briefly twice in a row.
✓ The vehicle horn or alarm siren is switched on.
✓ The hazard lights flash.
Switching off the panic mode
➤ Press the "Unlock" button on the hand-held transmitter.
✓ The panic mode is switched off.
EN
Using MagicSafe
51