Installing Magicsafe - Dometic MS660 Instructions De Montage Et De Service

MS660
7

Installing MagicSafe

I
NOTE
If you do not have sufficient technical knowledge for installing and
connecting the components in vehicles, you should have a specialist
install the alarm system in your vehicle.
Tools required (fig. 1, page 3)
7.1
For installation and assembly you will need the following tools:
• Measuring ruler (4)
• Centre punch (5)
• Hammer (6)
• Drill head set (7)
• Drill (8)
• Screwdriver (9)
To establish and test the electrical connection, the following tools are required:
• Diode test lamp (1) or voltmeter (2)
• Hot air blower (10)
• Crimping tool (11)
• Soldering iron (optional) (12)
• Solder (optional) (13)
• Insulating tape (14)
• Heat shrinking sleeve
• Cable bushing sleeves (optional)
To secure the cable you may require additional screws and cable binders.
EN
Installing MagicSafe
21