Dometic MS660 Instructions De Montage Et De Service page 23

MS660
7.5 Installing the bonnet contact switch
This switch only needs to be installed if the vehicle does not already have one.
➤ Choose a suitable position in the engine compartment.
➤ Drill a hole with a diameter of 8 mm.
➤ During installation, make sure the distance to the closed bonnet is between
22 mm and 27 mm.
Use putty, for example, to check this distance.
You can further reduce the minimum distance by shortening the switch.
➤ Test the switch function after installation.
7.6 Installing the key holder
I
NOTE
When selecting the installation location, observe the cable lengths.
➤ Select a suitable installation location near the dashboard.
➤ Drill a hole with a diameter of 15 mm.
➤ Push the sensors into the holders until they lock into place.
7.7 Installing the alarm sirens (accessory)
Instead of the vehicle horn, you can connect an alarm siren (e. g. ref. no. MS-620SI
or MS-670SI).
A
NOTICE!
When installing, ensure that the installation location is not an area where
water might splash, and that it is not close to the exhaust system.
➤ Install the alarm sirens in the interior of the vehicle.
EN
Installing MagicSafe
23