Dometic MS660 Instructions De Montage Et De Service page 39

MS660 Programming MagicSafe
Function 9 (Siren/vehicle horn selection)
This function determines whether the vehicle horn or an external siren (e. g.
MS-620SI) is used. When set to "Siren", the relay switches on to constant for 30 sec.
When set to "Horn", the relay switches on and off every second for the duration of
30 sec. This function can only be used when function 13 is programmed to "Starter
circuit breaker".
Function 10 (Locking the central locking during self-activation)
This determines whether the vehicle should be locked or not after self-activation of
the alarm system. This function can only be used when function 7 is programmed to
"On".
Function 11 (Locking/unlocking with ignition)
When this function is activated, you can lock the vehicle when the ignition is
switched on by pressing the "Lock" button. In this case, the alarm system is not
activated.
The central locking unlocks the vehicle automatically when the ignition is switched
off.
Alternatively, the vehicle can be unlocked any time by pressing the "Unlock" button.
Function 12 (Alarm detection for additional sensors)
MagicSafe features an additional alarm output (grey/white cable). This function
allows you to determine whether this sensor alone can trigger the alarms or whether
it is only triggered in combination with the ultrasonic sensors.
Function 13 (Additional relay function)
This function is factory-set for use as a starter circuit breaker. This is already active in
"Standby" mode, not just in the event of an alarm.
This function can only be used when function 5 is programmed to "On".
If function 13 is programmed to "Alarm output", then this relay can, in the event of
an alarm, activate an additional warning device (e. g. a pager) or a further siren or
horn. In this case, the starter circuit breaker is not activated.
The siren or horn option can be determined by function 9.
39
EN