Dometic MS660 Instructions De Montage Et De Service page 24

Installing MagicSafe
7.8 Installing additional radio sensors (accessory)
Installing the radio magnetic sensor (fig. 7, page 5)
The radio magnetic sensors allow you to lock e.g. roof boxes or caravan stowage
compartments or windows.
Observe the following installation instructions:
• Install the radio magnetic sensors in the interior of the vehicle.
• The interval between the magnet (3) and sensor (1) must not exceed 15 mm.
• Align the sensor so that the LED (2) points away from the magnet (3).
➤ Tightly fasten the magnet (3) to the door or to the window.
➤ Secure the sensor (1) to a fixed component (e. g. door or window frame) using
double-sided adhesive tape.
Do not cover the screws on the base with the adhesive tape.
➤ Test whether the interval is small enough:
When you open the doors, the LED (2) must light up once briefly.
Installing the radio motion sensor
When installing the motion sensor, observe the following instructions:
• Choose an installation location that allows the entire vehicle interior to be
monitored (fig. 8, page 5).
• The motion sensor can detect movements at a distance of maximum 12 m.
It cannot detect movements behind stationary objects such as partitions.
If appropriate, use several motion sensors.
• Try to avoid blind spots by positioning the sensors well.
• Do not install the motion sensor at a height of more than 2 m above the vehicle
floor.
• Do not install the motion sensor close to sources of heat, e. g. heaters,
or outlet nozzles for warm air.
➤ Press the housing of the motion sensor in slightly on both sides and remove it
from the rear wall (fig. 9, page 6)
➤ Screw the rear wall to a suitable installation location.
➤ Put the housing back onto the rear wall and click it into place.
24
MS660
EN