Dometic MS660 Instructions De Montage Et De Service page 40

Programming MagicSafe
Function 15 (Bonnet contact input)
This allows you to determine how the bonnet contact switch is connected.
The system is factory-set to a closed switch when the bonnet is open (voltage
0 volts). Should the switch used be open when the bonnet is open (voltage 12 volts),
function 15 must be programmed to "Switch opened when bonnet is open".
Function 16 (Door contact/boot input)
This allows you to determine how the door contact switch and the boot contact
switch are connected.
The system is factory-set to a closed switch when a door is open/boot is open
(voltage 0 volts). Should the switch used be open when the bonnet is open/boot is
open (voltage 12 volts), function 16 must be programmed to "Switch opened when
door is open".
I
NOTE
The boot contact switch only has to be connected if the lighting for the
passenger compartment (interior light) remains dark when the boot is
opened.
Function 18 (Car Finder/convenience function on)
This function allows you to determine whether the "COMFORT" button switches
additional convenience functions (e. g. Coming Home function) or whether it should
function as a Car Finder. In the second case, the indicators are activated for 10 min.
By pressing the "COMFORT" button again, the indicator will go out, the alarm
system remains activated.
If this function is programmed to "Car Finder", function 8 (Convenience function)
cannot be used.
Function 19 (Switch time for convenience locking function)
In order to be able to use the convenience function, function 4 must be programmed
to "On". In this case, the locking process remains activated for as long as the "Lock"
button is held down. On vehicles equipped with a factory-set convenience locking
module, the e. g. windows or the sliding sunroof can then be closed. Alternatively,
the locking process can be programmed to a fixed duration of 25 sec.
40
MS660
EN