Dometic MS660 Instructions De Montage Et De Service page 47

MS660
➤ Switch the ignition off.
➤ Release the button.
✓ You are now in learning mode.
✓ The status LED flashes 10 times and then lights up continuously to confirm.
I
NOTE
If you do not press a button within 10 seconds, you will exit the learning
mode.
Learning the hand-held transmitter
➤ Press the "COMFORT" button on the hand-held transmitter.
✓ The status LED goes out while the value is saved.
✓ If the status LED lights up continually again, then the hand-held receiver has been
learned and you can now proceed with the next one.
I
NOTE
Only exit learning mode when you have learned all the hand-held
receivers, electronic keys and radio sensors you wish to use. Hand-held
receivers and radio sensors which you do not learn during this phase will
be automatically unpaired from the system. They can only be used once
they have been learned again.
Learning the electronic key
➤ Insert the electronic key into the key holder on the dashboard.
✓ The status LED goes out while the value is saved.
✓ If the status LED lights up continually again, then the hand-held receiver has been
learned and you can now proceed with the next one.
Learning the radio motion detector (accessory)
➤ Switch the motion detector on using the switch.
✓ The read status LED on the motion detector flashes.
✓ The motion detector has been learned.
EN
Using MagicSafe
47