Dometic MS660 Instructions De Montage Et De Service page 20

Technical description
6.2 Hand-held transmitter control elements
Hand transmitters have the following control elements:
fig. 5, page 4
1
2
3
4
6.3 MagicSafe operating modes
The alarm system has the following five operating modes:
• Stand-by
The alarm system is kept in stand-by as soon as it is installed and correctly
connected. However, it does not trigger the alarm when in stand-by.
• Activation time
The alarm system has an activation time of approx. 30 seconds.
The status LED on the key holder lights up as an visual indicator of the activation
time.
• Armed
If the alarm system is activated, it can trigger the alarm. This happens if someone
e. g. breaks the door open, opens the bonnet or enters the vehicle interior. If you
wish to drive off, you must first deactivate the alarm system. The system is then in
stand-by mode.
The status LED on the key holder lights up as an visual activation indicator.
• Alarm triggered
When an alarm has been triggered, this is indicated by visual and acoustic
signals.
• Workshop mode
You can set the alarm to workshop mode if, for example, the vehicle is to be
handed over for repairs or inspection (see chapter "Setting workshop mode" on
page 51). In workshop mode, all settings for the alarm system remain stored,
even if the battery is disconnected. The alarm system can be activated and
deactivated without the hand-held receiver or the electronic key.
The status LED on the key holder lights up every 15 seconds as a visual indicator
of the activation time.
20
Designation
"Lock" button
"COMFORT" button
"Unlock" button
LED indicator (blue)
Function
Activates the alarm system
Activates the convenience output
Deactivates the alarm system
MS660
EN