Dometic MS660 Instructions De Montage Et De Service page 32

Connecting the power to MagicSafe
• Unlock the boot or fuel tank lid.
• Switch on the parking heating.
I
NOTE
You will require a convenience module or an operating current relay
with recovery diode, depending on your installation, for the con-
venience function.
Connecting the remaining connection cables (fig. a,
8.5
page 7)
Connecting the key holder
➤ Insert the red two-pin plug (22) of the connection cable into the red socket (22)
of the key holder.
➤ Insert the white two-pin plug (23) of the connection cable into the white
socket (23) of the key holder.
Connecting the ultrasonic module
➤ Insert the white three-pin plug (15) into the connection of the ultrasonic
module (18).
Connecting the ultrasonic senors
➤ Insert the red plug of the ultrasonic sensor cable (17) into the red connection of
the ultrasonic sensor (17).
➤ Insert the white plug of the ultrasonic sensor cable (19) into the white connection
of the ultrasonic sensor (19).
8.6 Connecting the gas detector MSG150 (accessory)
(fig. k, page 12)
➤ Disconnect the 12-volt plug from the gas detector cable.
➤ Remove around 10 cm of the outer insulation on the end of the cable.
➤ Connect the black cable to earth (terminal 31).
➤ Connect the yellow and the orange cable of the gas detector to the white cable
from MS660.
32
MS660
EN