Dometic MS660 Instructions De Montage Et De Service page 44

Using MagicSafe MS660
Reactivating the alarm system automatically
You can set MagicSafe so that the alarm system is reactivated automatically (software
function 7 "Self-activation", factory setting: deactivated) if the vehicle is not used
within 30 sec. of deactivating the alarm system (opening a door or switching on the
ignition). The indicator flashes twice to indicate this.
The central locking remains unaffected. If you wish the doors to be locked by central
locking self-activation, activate software function 10 "Locking the central locking
during self-activation" (factory setting: deactivated).
11.3 Deactivating MagicSafe
To deactivate the alarm system manually, proceed as follows:
➤ Press the "Unlock" button on the hand-held transmitter for approx. 1 sec.
✓ The hazard lights flash once.
✓ If the alarm system is connected to the central locking, all doors and covers are
unlocked.
Deactivating MagicSafe without the hand-held transmitter
If you have misplaced the hand-held transmitter, the batteries are empty, or the
hand-held transmitter is damaged, you can deactivate the alarm system with the
electronic key.
➤ Open the door using the vehicle key.
✓ The alarm system triggers an alarm.
➤ Insert the electronic key in the socket.
✓ The alarm system is deactivated.
If the electronic key has also been lost, the alarm system can be deactivated using the
PIN code. To enter the 5-digit PIN code, proceed as follows:
➤ Open the driver's door using the ignition key, triggering an alarm by doing so.
➤ Wait 30 sec. until the alarm stops.
✓ The status LED lights up continuously.
➤ Switch the ignition on for 1 sec. and off again within 5 sec.
✓ The status LED starts flashing.
44
EN