Grillo FD 280 Manuel D'utilisation page 16

3. Turn the lever anti-clockwise (fig. 25)
4. Remove the PTO belt (fig. 22)
5. Release the fork (fig. 20), pull the deck forward and set it vertical (fig. 17). Take care not to bend the adjuster
cables.
6. Remove the pulley (fig. 19A).
7. Take off the cutting deck protection transmission (A fig. 36), unscrewing the 4 screws;
8. Unhook the spring (A fig. 35);
9. Take off and put the belt (ref. B fig. 35), following the schema represented (fig. 35).
USE ORIGINAL BELTS ONLY!
PROCEDURE
check the level
Engine oil
change
check
Air filter
replace
check/adjust
Spark plug
replace
Hydrostatic
check the level
axle oil
replace
Check that the engine intake
grid is clean
Check that the hydraulic
engine cooling fins are clean
Check that blades are well-
sharpened and well-fixed
Lubricate with grease
● recommended procedure
‫ ٭‬procedure to be carried out if necessary
FD280/ Translation of the original instructions
MAINTENANCE SUMMARY TABLE
EVERY 8 AFTER
HOURS 20
HOURS
●
●
●
●
●
●
●
12
EVERY EVERY EVERY
40 50
HOURS HOURS HOURS
(first
change)
●
●
EVERY 200 HOURS
100
●
‫٭‬
●
●
●