Auxiliary Grid/Genset Connection Process - Ingeteam INGECON SUN STORAGE 1Play TL M Manuel D'installation

Auxiliary grid/genset connection

10.3. Auxiliary grid/genset connection process

Depending on the grounding system (TT or TN), follow the steps below.
TT grounding system
1. Pass the cable through the cable grommet marked as GRID/GENSET.
2. Insert the respective wires in the J82 GRID push-in type terminals, respecting the polarity. The neutral
connector must be connected to the J82 N
in "7. Connection/disconnection of wiring in push-in type
3. Check that the push-in spring connection is tight.
TN grounding system
1. Pass the cable through the cable grommet marked as GRID/GENSET.
2. Insert the respective wires in the J82 GRID push-in type terminals, respecting the polarity. The neutral
connector must be connected to the J82 N
3. Check that the push-in spring connection is tight.
ABH2014IQM01_A - Installation and Operation Manual
N TT
L
terminal. The operation of this type of terminal is described
TT
terminals".
L
N TT
terminal.
TN
Ingeteam
EN
ES
FR
PT
31