Connection/Disconnection Of Wiring In Push-In Type Terminals - Ingeteam INGECON SUN STORAGE 1Play TL M Manuel D'installation

Ingeteam

Connection/disconnection of wiring in push-in type terminals

7. Connection/disconnection of wiring in push-in type
terminals
The connection of the critical loads and the auxiliary grid/genset is performed using push-in type terminals.
This section describes the connection and disconnection process of the wiring in these terminals, as well as the
tool to use.
Required tool
To operate on these terminals, use a flat-head screwdriver with the maximum dimensions specified in the following
figure.
3
0,5
Wiring connection
Follow the steps below to connect the wiring to these terminals:
1. Insert the flat-head screwdriver in the specified slot.
24 ABH2014IQM01_A- Installation and Operation Manual